I can connect to the SkyFi3 adhoc network, I can connect to the SkyFi webpage. Following a two-star alignment, SS6 gives the error message: "SkySafari 6 Pro can make a wireless network connection to the scope, but the scope is not responding. Make sure it is connected and powered on. Also check that your scope type is correct." I have been able to connect to the scope once out of approximately one hundred attempts. I have not been able to replicate the success. The equipment data is below:
SS6 Pro v22.214.171.124
Android 9 v. 4.4.153-17214672 on a Galaxy S8+
Telescopes used: AWB 130mm reflector, AT102EDL refractor
SynScan V5 Handcontroller, firmware v. 4.39.15
SkyFi 3 using adhoc connection, connection is good (the config webpage is accessible)
Connecting to the SynScan controller via USB cable (USB in the SkyFi, USB in the SynScan)
SS6 Scope Setting: SkyWatcher SynScan
Alignment process is 2-star.
Additionally, I have verified that I can control the mount directly from a computer via USB connection using EQMOD. I have also verified that I can control the mount via EQMOD and the SynScan app through the USB connection to the hand controller.