Hello,
I can connect to the SkyFi wirelessly. But after aligning the scope and booting up Sky Safari 7 Pro, the scope does not connect.
I have checked the setup in Sky Safari, I could only enter the scope details in Equipment.
So far I have not been able to check or upgrade the firmware as I cannot connect the SkyFi to my computer with the USB connector.
I am connecting with an RS 232 serial attachment that connects to the AutoStar hand control through the attached serial (phone cord).
The connector I am using is the one I had from my Meade Stella controller. Perhaps, not compatible.
Any help you can extend will be most appreciated,
Thanks,
Mark