Fred reply #1: But still after installing SN Pro 8 I have my problems to connect the Telescope with PC. It appears always after a few minutes
"Connecting Failed to warm reboot. Power cycle the Autostar II and reconnect."
Did I need different cable connection with SN Pro 8 and Win10?
I check all my driver I need and can't find any problems.
Do you have any ideas?
Fred reply #2: I attached some screenshot and the error message!!!
Hope it will help you to find a positive solution for my problem.
Fred reply #3: finally, I get that the telescope moving!!!
When you switch from Win7 to "Win10 with Starry Night Pro 8" you only replace the USB connection to the 232 adapter and load a new driver for the USB port ( PL2303_prolific_Driverinstaller_v1210 ).
Don't buy the Meade USB to RS-232 adapter, that is not working!!!!
This one works fine and cost only 40% of the Meade one:
StarTech.com USB to Serial Adapter - 1 port - USB Powered - FTDI USB UART Chip - DB9 (9-pin) - USB to RS232 Adapter (ICUSB2321F),Black
