Last night I got Skysafari to connect using StarSense along with the Celestron module app. I started an auto align (which worked fine two nights ago and many times in the past), I got the first two stars aligned, at that point I got an error message saying that the skysafari could no longer connect (also, I couldn’t cancel out of Skysafari, had to reboot the iPad). Once again, rebooted, changing USB ports, power on and off, etc., etc. No luck. Tried the SkyPortal app and it too could not connect! Since SkyPortal was also unable to connect to the WiFi, I’m guessing this was unrelated to the Skysafari app. However, do you have any idea (or even a guess) what the possible cause of both apps being unable to connect could be? (note the Celestron Wifi signal was designated in settings)
Much thanks....
Joe
